Side drum plate - 300mm

The right side of the drum is responsible for maintaining one of the winding limits of the hose. If the side plate is bent, cracked or has damaged mounting points, the hose may wind unevenly, rub against the edge or move outside the correct winding path. At a diameter of 300 mm, this is a component that must retain the correct shape along its entire circumference.

APPLICATION

The right side plate is used in the hose drum assembly as a part that limits and guides the winding from the right side. It works together with the other side of the drum, the axle, mounting elements and the high-pressure hose, so its condition affects the way the hose is arranged during winding and unwinding.

In service practice, replacement is necessary after impact, edge deformation, cracking at the mounting point or when the drum begins to operate with visible lateral wobble. Damage of this type does not always immediately disable the reel, but it can gradually worsen hose guidance and increase the load on neighboring drum components.

SYMPTOMS - WHEN IT IS WORTH REPLACING

• the hose winds unevenly and shifts toward the right edge of the drum
• the side plate has cracks, deformation or damaged mounting points
• visible wobble or uneven operation appears on the right side of the reel during rotation
• the edge of the plate rubs against the hose or adjacent housing components
• after disassembly, worn holes, a deformed profile or a damaged outline of the component are visible

HOW TO CHOOSE THE CORRECT COMPONENT

When selecting this part, it is necessary to confirm not only the 300 mm diameter, but also the right-hand installation side. Side plates may look similar, but differ in mounting layout, edge profile or the way they work with the axle and the remaining reel components.

Before installation, it is worth checking:

• plate diameter 300 mm
• right-hand installation side
• arrangement of holes and mounting points
• profile of the hose-guiding edge
• compatibility with the axle, the other plate and the drum body
• condition of spacer and mounting elements

The geometry of the entire circumference is important in this part. Even a slight bend or profile difference may cause uneven hose guidance and accelerated wear of the drum edge.

COMPATIBILITY

Compatibility should be assessed according to the specific drum design, not only the outer diameter. Correct fit is determined by: the right-hand installation side, 300 mm diameter, plate profile, mounting layout and the way it works with the other reel components. In drum side elements, similar appearance does not guarantee correct operation, because even a small geometry difference may change the hose guidance path.

[faq]

Can the right side plate be swapped with the left one?|If the part is specified as right-hand, correct fit depends on the installation direction, mounting layout and the profile of operation with the specific side of the drum.

What can cause the hose to shift to one side of the drum?|The cause may be a deformed side plate, play on the axle, uneven drum mounting or incorrect hose guidance during winding. It is worth checking the entire hose path.

How can you check whether the plate wobbles after installation?|After fitting, the drum should be rotated and the side edge observed to see whether it runs evenly. Visible edge waviness usually indicates plate deformation, a seating problem or damage to the mounting elements.

Does a crack near a mounting hole disqualify the plate from further use?|Usually yes, if the crack affects the stiffness of the component or enlarges during drum rotation. Loads repeat in this area during every hose winding cycle.

What should be checked together with the right drum plate?|It is worth inspecting the left plate, axle, spacers, screws and the hose itself. If the right side was overloaded or hit, adjacent elements may also have absorbed part of the damage.

[/faq]