Socket D10 - M22

The D10–M22 connector for the Home series is a connection part for high-pressure systems, enabling setup between D10-standard accessories and an M22 fitting. It is used during servicing and accessory configuration when connection compatibility is needed without replacing the entire working set.

MPN / reference: 13430

APPLICATION

The connector is used in typical technical work:

• adapting connections between D10 accessories and components with M22 thread,
• configuring hose, gun, and accessories in Home systems,
• service and modernization work on pressure washers,
• preparing a working set for different cleaning tasks.

KEY BENEFITS IN USE

In practical operation, the D10–M22 connector provides:

• quick adaptation between two connection standards,
• easier accessory expansion without rebuilding the whole system,
• greater flexibility in selecting working accessories,
• smoother workflow in service and workshop environments,
• repeatable assembly with frequent configuration changes.

HOW TO USE IN PRACTICE

For leak-tight and stable operation:

• confirm end compatibility: one side D10, the other M22,
• before assembly, inspect thread condition and contact surfaces,
• assemble axially, without cross-threading/misalignment,
• after installation, perform a leak test at working pressure.

Proper installation reduces leak risk and premature connector wear.

COMPATIBILITY

Compatibility should be confirmed by:

• MPN 13430,
• connection standard: D10–M22,
• device/accessory documentation for Home series (e.g., 1050 P, 1050 TS, 1050 TST).

[faq]

• What is the D10–M22 connector used for?|It is used to connect accessories when one system includes two different fitting standards: D10 and M22.
• Will this connector fit every Home-series model?|This should be confirmed by MPN 13430 and the actual fitting types used in the specific machine.
• Is it only a service part, or also for daily use?|It can serve both roles: as an adapter used in service and as a permanent part of the working setup.
• Can I select the connector based only on “M22”?|No. You need to confirm the full connection spec (D10–M22) and compatibility with accessories and technical documentation.
• How can I avoid leaks after installation?|Key points are: correct standard compatibility, clean contact surfaces, proper tightening without misalignment, and leak testing under pressure.

[/faq]