Drum Connection Elbow 1/4"-M14x1,5

The drum-to-pump connection rarely runs in a straight line - the difference in thread standards on both sides and the housing geometry force a change of direction. Elbow 40179 solves both problems simultaneously: it changes the connection routing direction by 90° and transitions between 1/4" and M14x1.5 thread.

Application

The elbow is installed at the connection point between the hose reel drum hydraulic installation and the Kranzle pressure washer pump. The component operates under pump working pressure every time the drum is used.

Symptoms - When to Replace

• Leakage at the 1/4" or M14x1.5 thread - water seepage in the drum connection area under working pressure.
• Damaged thread on either side - the elbow does not tighten securely or resistance during tightening is irregular.
• Cracked fitting body - a visible crack or fracture after excessive tightening or mechanical impact.
• Pitting on the thread preventing a lasting seal at the connection.

How to Select the Correct Part

Elbow 40179 connects two different thread standards - 1/4" and M14x1.5. Before ordering, confirm which thread is on the drum side and which is on the pump side in the specific washer model. Reversing the installation sides on an asymmetric fitting results in an impossible connection. Reference number 40179 is the basis for selecting the correct variant - the Kranzle range may include elbows of similar geometry but different thread configurations.

Compatibility

Kranzle catalogue part. Used among others in Kranzle pressure washers equipped with a hose reel drum with M14x1.5 and 1/4" connections. Verify compatibility with a specific model using reference number 40179 or the drum service diagram.

[faq]

Can elbow 40179 be replaced with a standard hydraulic fitting from a general technical supplier?|The combination of 1/4" and M14x1.5 in a single angled fitting is not a common standard in general hydraulic supply ranges. Fittings with this type of thread configuration are a Kranzle catalogue component matched to the specific drum installation geometry. Using non-standard substitutes requires precise confirmation of both thread dimensions, the angle, and the fitting length on both sides. 

[/faq]