Microswitch cover

Microswitch cover 15201 closes the working area of the microswitch in Kranzle pressure washers. Its role is to shield and stabilize this section of the assembly without changing the electrical function of the switch itself.

APPLICATION

The component is used within the microswitch mechanism, where proper housing closure, space for wiring, and lack of pressure on moving internal parts are important. The cover should sit evenly and mount without forcing neighboring components.

Replacement is justified when the original cover is cracked, missing a fragment, no longer holds securely on its mounting point, or does not properly close the microswitch compartment after assembly. During repair, it is also worth checking the condition of screws, mounting seats, and wire routing beneath the cover.

SYMPTOMS – WHEN REPLACEMENT IS RECOMMENDED

The cover should be replaced when its damage affects closure or stability of the microswitch assembly:

• cracked cover near the mounting point,
• cannot be tightened evenly,
• cover lifts away after assembly,
• broken section responsible for shielding the switch,
• screw no longer clamps the cover securely.

A superficial scratch alone has no service importance if the cover still closes properly and remains stable on its mounting points.

HOW TO SELECT THE CORRECT PART

The cover should be selected according to reference number 15201 and compared with the removed component. Important factors include shape, mounting layout, edge contour, and the way the microswitch compartment is closed.

Before installation, check:

• reference number 15201,
• cover shape compared to the original part,
• mounting hole positions,
• screw condition,
• condition of mounting seats in the cooperating component,
• whether wires under the cover are being pinched.

If the cover does not close properly despite the correct part number, the issue may be caused by incorrectly routed wiring.

COMPATIBILITY

Microswitch cover 15201 is used in Kranzle pressure washers. Selection should be based on the reference number and comparison with the removed microswitch cover.

[faq]

Can incorrectly routed wiring prevent the cover from closing?|Yes. Space around the microswitch is limited, so wiring routed differently from the original layout may lift the cover or twist it during tightening.

What should be checked if the cover cracks again after a short time?|Check whether the screw is being overtightened, whether the mounting seat is misaligned, and whether something beneath the cover blocks proper closure. Repeated cracking usually indicates stress at the mounting point.

[/faq]