Chemical suction hose 800 mm

Chemical suction hose 465480 works in the detergent intake system. The 800 mm length allows the hose to be routed between the detergent pickup point and the suction point in the washer without excessive tension or accidental kinking.

APPLICATION

The hose is used in the detergent system of Kranzle pressure washers. Its purpose is to draw cleaning chemical from a container, tank, or designated suction point and deliver it to the dosing system.

In service practice, the hose should remain unobstructed, leak-free, and properly seated on the connections. In detergent suction systems, even a small leak, hose kink, or contamination inside the hose may reduce detergent pickup or completely stop suction.

SYMPTOMS - WHEN REPLACEMENT IS RECOMMENDED

Replacing the chemical suction hose may be necessary when the following issues occur:

• no detergent pickup despite correct settings,
• air being drawn through a leaking connection,
• hardening, flattening, or kinking of the hose,
• cracks near the ends or at bend points,
• detergent deposits restricting hose flow,
• the hose slipping off the fitting or failing to stay securely attached.

Surface contamination on the hose does not automatically indicate damage. What matters are leaks, blockage, loss of flexibility, and the condition of the ends responsible for stable connection to the detergent system.

HOW TO SELECT THE CORRECT PART

The hose should be selected based on the 800 mm length, reference number 465480, and the connection method used in the detergent system. Before installation, compare the new hose with the removed one: length, diameter, flexibility, seating method on the fitting, and routing inside the machine housing.

A hose that is too short may place tension on the connection, while a hose that is too long may form loops or kink during operation. In detergent suction systems, it is also important that the hose is not flattened and does not leak at the ends.

COMPATIBILITY

Chemical suction hose 465480 has a length of 800 mm and is used as part of the detergent system in Kranzle pressure washers. Selection should be based on the reference number, hose length, and compatibility with the detergent dosing system connections.

[faq]

Why does the washer not draw detergent even though detergent is present in the container?|The cause may be a leaking hose, blocked line, kinked section, or incorrectly seated hose end on the fitting. It is also worth checking the filter or pickup element if used in the given configuration.

Can the 800 mm length be replaced with a different length?|It is best to keep the length intended for the specific system. A shorter hose may be under tension during operation, while a longer hose may kink or make proper routing inside the housing more difficult.

What does air suction in the detergent system mean?|Air suction usually indicates a leak on the hose side, hose end, or fitting. The hose may look fine externally but still draw air near the end or at a bend point.

When might the issue not be caused by the hose itself?|If the hose is unobstructed, flexible, and securely connected, check the dosing setting, suction fitting, detergent filter, and the condition of the components working with the detergent intake system.

[/faq]