Cable winding holder

Holder 44505 is a mounting plate used to secure the cable to the housing of a Kranzle pressure washer. The component keeps the cable organised and maintains it in the intended position during storage and transport of the machine.

APPLICATION

The part operates in the external housing area where the cable is routed or stored after use. Its role is to keep the cable secured to the machine without looseness, unwanted movement, or hanging outside the intended position.

During repair, stable fastening of the plate and correct contact with the housing are important. If the holder is cracked, torn out, or does not sit evenly, the cable may become unstable and interfere with normal washer operation.

SYMPTOMS – WHEN REPLACEMENT IS RECOMMENDED

Replacing the holder makes sense when damage affects cable mounting or routing:

• cracked or broken mounting plate,
• torn section near the mounting hole,
• looseness after tightening the screws,
• cable no longer stays in position,
• holder bends when placing the cable,
• component does not sit evenly against the housing.

Superficial signs of use are not a reason for replacement if the holder still secures the cable properly and can be fastened correctly.

HOW TO SELECT THE CORRECT PART

The holder should be selected according to reference number 44505 and by comparison with the removed plate. The most important factors are shape, hole spacing, contact surface with the housing, and cable support position.

Before installation, check:

• reference number 44505,
• hole layout and spacing,
• plate shape compared to the old component,
• condition of mounting screws,
• condition of mounting seats in the housing,
• whether the cable sits without tension after installation.

If the previous holder was torn out, inspect the mounting area in the housing as well. A new plate will not eliminate looseness if the screw no longer has a solid mounting point.

COMPATIBILITY

Cable winding holder 44505 is used in Kranzle pressure washers as a cable mounting plate. Selection should be based on the part number and compatibility with the removed component.

[faq]

Why can the holder still have play even with the correct part number?|Most often due to worn screw seats, damaged housing around the mounting area, or screws that no longer clamp the plate properly.

Can the old screws be reused when replacing the holder?|Yes, if the thread, screw head, and clamping surface are still in good condition. If the screw spins freely or no longer tightens evenly, the mounting will remain unstable even with a new holder.

Will the holder alone solve a poorly positioned cable problem?|Not always. If the cable has become stiff, twisted, or routed incorrectly near the housing exit, it may still sit improperly even with a new holder.

What should be checked before final tightening of the plate?|Position the cable in its intended location and check whether the plate sits evenly against the housing without tension. Only then can tightening the screws confirm stable mounting.

[/faq]