Lance tube 1000 mm 1/4"

Lance tube 13519 has a length of 1000 mm and a 1/4" thread, making it a long, rigid working section in the pressure washer accessory system. In this version, the straightness of the tube, thread condition, and comfortable lance handling with the nozzle positioned further from the operator are especially important.

APPLICATION

The tube is used as part of the working accessories in Kranzle pressure washers. It connects the gun, handle, or another connection element with the working tip, nozzle, or additional equipment matched to the 1/4" thread.

The 1000 mm length is suitable for configurations where a shorter lance does not provide sufficient reach. This type of section can be useful when cleaning larger surfaces, components positioned further from the operator, or areas where maintaining distance from the working spray is important.

SYMPTOMS – WHEN REPLACEMENT IS RECOMMENDED

Replacing the lance tube may be necessary when the following issues occur:

• damaged, seized, or stripped 1/4" thread,
• leakage at the connection with the gun, handle, or working tip,
• clearly bent tube after impact or overload,
• corrosion in the thread area or near the ends,
• inability to tighten the cooperating component securely,
• unsuitable length compared with the required accessory configuration.

Minor signs of use on the steel surface are not a reason for replacement. What matters are defects affecting tightness, axial alignment, thread condition, or secure tightening of the connections.

HOW TO SELECT THE CORRECT PART

Selection should be based on the 1000 mm length, 1/4" thread, and reference number 13519. Before installation, compare it with the previous component: total length, end type, thread condition, and connection method with the remaining lance parts.

In this version, thread compatibility alone is not enough. The 1000 mm length significantly changes reach and handling of the accessories, therefore it should match the intended application or the previous working configuration.

COMPATIBILITY

Lance tube 13519 has a length of 1000 mm and a 1/4" thread. It is used as part of Kranzle pressure washer accessories in systems requiring a long steel working tube with this connection.

[faq]

Do light traces of corrosion near the end automatically disqualify the tube?|Not always. The important factor is whether the corrosion affects the thread, makes tightening difficult, or reduces connection tightness. Superficial surface oxidation outside the thread area is usually less important than the condition of the connection itself.

Why should this tube not be selected only by the 1/4" thread?|The thread defines the connection method, but it does not determine length or lance handling. A 1000 mm tube works differently from shorter versions, so selection should consider both the connection type and the required working reach.

[/faq]