Lance for Starlet gun 342 mm 1/4" ISO Griff

Lance 150045 works directly with the Starlet gun and forms an intermediate section between the handle and the working accessory. This version has a length of 342 mm, a 1/4" connection, and ISO Griff design, therefore compatibility with the gun and mounting system is important during replacement.

APPLICATION

The lance is used as a gun tube in working sets for Kranzle pressure washers. It allows the working point to be positioned further from the gun handle and creates a rigid section for mounting additional spray equipment compatible with the connection type used.

In everyday operation, straightness of the lance, connection tightness, and the condition of the 1/4" thread are important. A damaged or incorrectly selected tube may cause tightening problems, leakage at the connection, or uncomfortable positioning of the accessory relative to the cleaned surface.

SYMPTOMS – WHEN REPLACEMENT IS RECOMMENDED

Replacing the lance may be necessary when the following issues occur:

• damaged or worn 1/4" thread,
• leakage at the connection with the gun or additional accessories,
• inability to tighten securely to the handle,
• visible damage to the connection end,
• mismatch in length or mounting type relative to the Starlet gun.

For a lance, the condition of both connection ends is important. A superficial scratch on the tube itself does not necessarily matter if the element remains straight, leak-free, and can still be mounted correctly.

HOW TO SELECT THE CORRECT PART

Selection should be based on the Starlet gun, 342 mm length, 1/4" connection, and ISO Griff version. Before installation, compare the new lance with the removed part: overall length, handle type, thread, end shape, and seating method in the gun.

Reference number 150045 helps confirm the correct variant. For lances and gun tubes, similar length alone is not always sufficient, because the connection standard and compatibility with the handle are also important.

COMPATIBILITY

Lance 150045 is intended for the Starlet gun in 1/4" ISO Griff version. It has a length of 342 mm and serves as a working tube mounted to the Kranzle pressure washer gun.

[faq]

What should be checked if the lance cannot be tightened correctly?|First inspect the 1/4" thread, seal condition, and the start of the thread in the gun. The issue may result from a damaged end, thread contamination, or an incompatible connection standard.

Is thread diameter alone enough for selection?|Not always. In addition to the 1/4" thread, the ISO Griff version, 342 mm length, and compatibility with the Starlet gun must also be considered. Together, these parameters define the correct variant.

When is leakage not caused by the lance itself?|If the lance thread is intact but the connection still leaks, inspect the seal, the socket in the gun, and the element mounted on the opposite side. Leakage often appears at the junction of several components, not only on the tube itself.

[/faq]