Tank to pump hose - Quadro 800/1000/1200

Hose 465480 connects the tank with the pump in Kranzle Quadro 800, 1000, 1200 pressure washers. It works between the tank section and the pump system, so its condition affects proper water flow and connection tightness.

APPLICATION

The hose is used as a connecting line between the tank and the pump in selected Quadro series models. It works in a place where secure seating on the fittings, absence of kinks, and unobstructed flow are important.

In service practice, this type of hose is replaced when leakage, hardening, damaged ends, or routing problems inside the machine housing occur. It is not a high-pressure lance hose, but an internal connecting element between the tank and the pump.

SYMPTOMS – WHEN REPLACEMENT IS RECOMMENDED

Replacing the hose may be necessary when the following issues occur:

• leakage at the tank or pump connection,
• crack near the hose end,
• hardening or loss of flexibility,
• kink restricting water flow,
• hose slipping off the fitting,
• visible signs of ageing or permanent flattening.

Surface contamination on the hose does not automatically require replacement. What matters are defects affecting tightness, flow, and stable hose seating.

HOW TO SELECT THE CORRECT PART

The hose should be selected based on the machine model, reference number 465480, and the connection method between the tank and the pump. In this case, the hose fits Quadro 800, 1000, 1200 models.

Before installation, compare the new hose with the removed part: length, diameter, end shape, routing inside the housing, and seating method on the fittings. Excessive bending after installation may restrict flow, while loose seating on the end may cause leakage.

COMPATIBILITY

Hose 465480 fits Kranzle Quadro 800, Quadro 1000, Quadro 1200 pressure washers. It connects the tank with the pump and works as an internal connecting hose in the water system.

[faq]

What should be checked if the hose leaks at the fitting?|Check the condition of the hose end, clamp or fastening, fitting surface, and whether the hose has hardened. Leakage often appears at the hose end, where the material works under the clamp.

Can a kinked hose restrict pump operation?|Yes. If the hose is bent or flattened, flow from the tank to the pump may be restricted. During installation, it should be routed without a sharp bend and without pressure from adjacent components.

Is reference number 465480 enough for selection?|The reference number is the main identification point, but it is worth matching it with the machine model: Quadro 800, 1000, 1200. During replacement, it is also advisable to compare the hose with the removed part.

[/faq]